1）DPI+/-:

Press the DPI key to switch the DPI value, four DPI levelcan be switched: 800-1200-2400-4800,which the default value is 1200dpi.

2）Light effect:

 LED button is for the light control, as following: colorful streaming light, Mixed color flow, Colorful wave, Red light, Green light, Blue color, Colorful Breathing. Colorful gradient, Turn off the light.

3）Mouse Sleep:

The mouse will enter the first level of hibernation without using in 1 minute, if for 10 minutes without using, the mouse will enter the depth of hibernation, any key randomly can wake up the mouse.

4）Recharging:

when the mouse is charging, the red light of wheel is always on, charging is completed after the red light off. When the mouse battery voltage reaches lower than the normal use requirements, the mouse decorative lights will go out, the using is not normal, after charging, the mouse works normally.

5）Re-charging time: 2.5-3 hours for a full charge

6）Standby time: 180days

7）Working time: 7-10 days after fully charged.

Installation and use steps: (lower schematic)：

 1）2.4G wireless connection method：

2.4G-switch button to 2.4G mode, plug usb receiver , Green light is flashing, mouse can use .Power off when Switch is in the center of position.

2）BT5.1 wireless connection method:

BT mode-switch button to BT,blue light is flashing,pc will search BT automatically, and confirm it, then it can use; if you wanna connect another pc, pls switch bt mode again and press left and middle key 3 seconds at the same time, pc search BT singal and choose to connect.